1/4 in Hex Bit Bar
==================

What it holds: Nine 1/4 in hex bits lie on a flat face in hex troughs, so they cannot roll.

PRINT SETTINGS
  Filament:  PETG
  Walls:     5
  Infill:    35% gyroid
  Orientation: the files are already oriented for printing. Put them on the plate as they load;
               don't rotate them.

FILES AND SUPPORTS
  - insert_ID_hex_bits.stl  (supports: no)
      how it lies on the plate: upright on its feet (STL already oriented), no supports; filament change at the tab-top layer z = 17.2 for white letters

HOW IT MOUNTS
  Case insert: it has no mount of its own. It drops into the Gridfinity-compatible floor of a clear-lid cart case (on this site) or any Gridfinity baseplate.

HOW IT WORKS
  Nine 1/4 in hex bits lie on a flat face in hex troughs, so they cannot roll. Each one stands half proud, and a nail notch at the back end lets you tip it up.
  Holds
  9 x 1/4 in hex bits (25 mm insert bits) lying in hex troughs, half proud so a fingertip tips them out; a nail notch at the end of every trough.
  Numbers

  - Grid: 2x1 Gridfinity units, 2u (rim 17.8 mm, no stacking lip)
  - Outside: 83.5 x 41.5 x 17.8 mm
  - White letters: filament change at z 17.2 mm
  Grid: the bins are Gridfinity-compatible (Gridfinity by Zack Freedman, MIT licence). The 42 mm grid, the 7 mm height unit and the standard base foot were modelled from the published spec. They drop into any Gridfinity baseplate, and into the clear-lid DOCK cases in this collection. They have no stacking lip. Instead the rim sits at 7u + 3.8 mm, which is no taller than a standard bin with its lip, so they fit any case that takes standard bins.
  Printing
  It fits the clear-lid DOCK cases in this collection, which hang on Magliner / Backstage cart lips, ToughBuilt bars and tubes. Not affiliated with Magliner, Backstage Equipment, Sharpie or ToughBuilt.

TEST THE FIT FIRST
  Carts, bars and tape rolls vary a little. Before a long print, print the small fit test from the
  Test pieces section of the site (or this part at low infill) and check it on your own gear.

More holders and the latest versions: https://cart-tools.sdos-placeholder.workers.dev/#insert-id-hex-bits

Not affiliated with or endorsed by Magliner, Backstage Equipment, ToughBuilt, Milwaukee, Hollyland, Eartec, Sekonic, Inovativ, Matthews or Manfrotto. Brand names only say what a holder fits.
