Comtek Receiver Row (3 + Cleats) - Backstage cart lip (one piece, strongest)
======================================================================

What it holds: 3 Comtek receivers with earset cord cleats (receivers only)

PRINT SETTINGS
  Filament:  PETG
  Walls:     5
  Infill:    35% gyroid
  Orientation: the files are already oriented for printing. Put them on the plate as they load;
               don't rotate them.

FILES AND SUPPORTS
  - clip_MB3_comtek_row.stl  (supports: no)

HOW IT MOUNTS
  BACKSTAGE CART LIP (ONE PIECE, STRONGEST)
    The cart-lip slot is printed into the holder, so it is one piece and as strong as it gets.
    Hold it tilted, hook the slot over the upright lip on the edge of a Magliner / Backstage-style cart
    shelf, and rock it down until it sits flat against the side.

    Notes for this holder: Default: one piece with the Backstage/Magliner cart-lip mount, strongest. Prints standing on its end face, no supports; M5 heat-set insert + thumbscrew lock on the lip.

HOW IT WORKS
  A home for three Comtek receivers at video village: each bay holds an IFB receiver and keeps its earset cord wrapped.
  Bays
  Three pockets at 70 mm pitch, each 34 x 66 mm inside and 60 mm deep, for Comtek PR-216 (27 x 57 x 83 mm) and similar IFB beltpacks up to about 33 x 62 mm, belt clip on. The receiver drops in standing up and stands 23 mm proud of the rim, so you grab it one-handed. It has to lift 60 mm to come out, so bumps and a lift-gate drop do not throw it. Each pocket has a 1.5 mm lead-in, a V thumb notch in the front so you can see the receiver and its channel label, and a drain.
  Cord cleats
  Each bay has a T cleat on the front, 14 mm proud, with ears at both ends and a 6 mm wrap gap. Wind the earset cord round it in a figure-8. A label flat under each cleat takes a name or channel.
  Headsets: this row holds receivers only, with earsets or earbuds wound on the cleats. It has no place for headphones. For a full Comtek kit (receiver plus its light on-ear headset) use the Comtek Kit Bay, and slide two or three of those side by side for a row. Note that a PR-216 uses its earset or headset cable as the antenna, so leave the cord plugged in and wound loosely.
  Numbers

  - Sticks out 59 mm from the cart side
  - Hangs 67 mm below the deck (the block top stands 42 mm above it, as on every part in the range)
  - Needs 45 mm of flat cart side below the lip for the back plate
  - Each part 77 x 214 x 109 mm (out x along the cart x tall)

OTHER MOUNTS
  The same holder also comes ToughBuilt bar (one piece), Dock (swap between mounts), Mountless (desk, shelf, case or screw to a panel). Pick the mount on the site: https://cart-tools.sdos-placeholder.workers.dev/#mb3-comtek-row

TEST THE FIT FIRST
  Carts, bars and tape rolls vary a little. Before a long print, print the small fit test from the
  Test pieces section of the site (or this part at low infill) and check it on your own gear.

Not affiliated with or endorsed by Magliner, Backstage Equipment, ToughBuilt, Milwaukee, Hollyland, Eartec, Sekonic, Inovativ, Matthews or Manfrotto. Brand names only say what a holder fits.
