Drill Grip Fork Gauge (30-44 mm) + Rocker Band Coupons
======================================================

What it holds: 25-minute slot gauge plus two short fork-mouth coupons: find your slot, then check the direction switch and the click on the real tool.

PRINT SETTINGS
  Filament:  PETG
  Walls:     5
  Infill:    35% gyroid
  Orientation: the files are already oriented for printing. Put them on the plate as they load;
               don't rotate them.

FILES AND SUPPORTS
  - RE_fork_gauge.stl  (supports: no)
      how it lies on the plate: flat, numbers up, no supports, about 25 min

HOW IT MOUNTS
  Test piece: lies flat on the bench, used to check fit before printing the real parts.

HOW IT WORKS
  Slot gauge: eight slots, 30 to 44 mm in 2 mm steps, each labelled. Slide each one onto the tool grip right under the head. The holster slot should be 1-2 mm wider than the tightest slot that fits. The 12 V holster uses 34 and the 18 V uses 40.
  Band coupons (12 V and 18 V): the real fork mouth of each holster at its full 16 mm thickness, with the click fingers and the rocker notches. Push it up the grip until it touches the head. The forward/reverse rocker must switch both ways, the trigger must not touch, and the bumps must click in front of the grip. The 18 V coupon also checks the 18 V drill holster.

TEST THE FIT FIRST
  Carts, bars and tape rolls vary a little. Before a long print, print the small fit test from the
  Test pieces section of the site (or this part at low infill) and check it on your own gear.

More holders and the latest versions: https://cart-tools.sdos-placeholder.workers.dev/#re-fork-gauge

Not affiliated with or endorsed by Magliner, Backstage Equipment, ToughBuilt, Milwaukee, Hollyland, Eartec, Sekonic, Inovativ, Matthews or Manfrotto. Brand names only say what a holder fits.
